USB to RS485 problem

USB 2.0 - USB 3.0 - FireWire - Hubs - Cables - Adapters
2 posts Page 1 of 1
 Post a reply  
j.roberts
New member
Posts: 1
Joined: Mon Oct 01, 2012 11:24 am
by j.roberts » Tue Oct 02, 2012 8:44 am
Reply with quote
I have a problem with the Model 42845 USB to RS485

Any command sent through it seems to just echo back that command and not transmit the information.

Before I send it back I was wondering if you could shed light on this at all?

 

LINDY John
LINDY Staff
Posts: 195
Joined: Mon Oct 03, 2011 9:46 am
by LINDY John » Tue Oct 02, 2012 9:38 am
Reply with quote
Normally the default configuration for the device is Loopback off, so this is a little surprising. It may be that the jumper settings within the device have been configured to leave loopback on, so I would need you to return the item to test this. My only other thought is that there is a loopback setting in the software you are using which needs to be set to off.
 Post a reply  
2 posts Page 1 of 1
Return to “USB & FireWire Products”